Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
INSTALLATION
Installation Planning
Planning is the key to fast, easy installation. Before a hole is drilled or a
wire is run, inspect the vehicle and determine how and where you intend
to mount the junction box, phone cradle, speaker, visor microphone,
remote PTT button, remote palm microphone (optional), and speaker
(see Figure 1). Plan wire and cable runs to provide maximum protection
from pinching, crushing and overheating.
5-AMP
BLADE-TYPE
FUSE
Red
TO IGNITION
BULLET-TYPE
CONNECTOR
Black
VEHICLE
CHASSIS
FROM REMOTE-MOUNT PTT
EXTERNAL
SPEAKER
HANDS-FREE
VISOR
MICROPHONE
Figure 1. Car Kit Interconnection Diagram
A properly installed Car Kit will minimize service calls and equipment
downtime. Refer to the following guidelines when planning the installa-
tion:
•
Use the provided hardware for mounting.
•
Ensure that the cables are not stretched, and not subjected to heat
from engine or transmission.
•
Crimp connectors securely.
•
Do not attach components to any part of the vehicle that is not rigid
or is subject to excessive vibration.
•
Do not run cables over sharp edges that could cause wear or
chaffing of cable insulation.
•
Do not install the components in locations where they might cause
interference to the operation of the vehicle controls.
4
CAR KIT OWNER'S MANUAL
VEHICLE
ANTENNA
POWER
CABLE
DATA CABLE
(OPTIONAL)
PALM MIC
(Optional)
Publicité
Table des Matières
