Airfusion Radar Installation Instructions
HANGING THE FAN MOTOR ASSEMBLY
1.Lift the fan assembly to the mounting bracket (1) and let the J-hook of the mounting bracket (4) go through
the hole of the hanging plate and hang up the fan assembly (3). Fig. 6
2.Connect the male and female connector together (2). Fig. 6
3. Pull the saftey cable (5) on the scew (6) and tight . lock the scew (6) into the ceiling through the hole of
mounting bracket , tight the safety cable .
4.Complete the electrical wiring using the diagram below (Figure. 7).
WARNING: To avoid possible electrical shock, be sure you have turned off the power at the main circuit panel.
Follow the steps below to connect the fan to your household wiring. Use the wire connecting nuts supplied
with your fan. Secure the connectors with electrical tape. Make sure there are no loose wire strands or
connections.
Fig. 7
4 | P a g e
ELECTRICAL WIRING DIAGRAM
1.
Connect the household live supply wire (black) to EMI filter
input wire (black, AC IN L) as shown in Fig. 7.
2.
Connect the household neutral supply wire (white) to the EMI
filter input wire (white, AC IN N).
3.
Connect the household ground wire to the EMI filter ground
wire (green). Connect the ground wire connectors together.
4.
Connect the EMI filter output wire (black, TO MOTOR L) to
motor live input wire (black, TO MOTOR L).
5.
Connect the EMI filter output wire (white, TO MOTOR N) to
motor neutral input wire (white, TO MOTOR N).
6.
After connecting the wires, spread them apart so that the
green and white wires are on one side of the outlet box and the
black and blue wires are on the other side.
7.
Turn the connecting nuts upward and push the wiring into the
outlet box.
Fig. 6
C T