Height Adjustment Of Brush; Angle Adjustment Of Brush; Technical Specifications; Troubleshooting - Texas A/S Handy Sweep Serie Manuel D'utilisation

Height adjustment of brush

When the brushes become worn it might be necessary
to adjust the proximity of brushes to the working
surface. To adjust the height of the brushes follow
figure 7:
1. Remove the lock pin
2. Lift the front of the machine to free the brush
and pull the supporting wheels out.
3. Remove or add the spacer ring
(1 ring = approx. 5 mm)
4. Install support wheels, remove / add spacer
ring, fasten with locking pin.
(Hint: Complete one wheel at a time)

Angle adjustment of brush

The brush can be pivoted 20 degrees to either side.
This is done by pushing the swing handle down,
turning the brush and releases the handle so the
detent clicks into place.
The swing handle is shown on Figure 6, H.

Technical specifications

Model
HS619TG
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush (positions)
Gears (forward/reverse)
Tire size 13 x 4.10 13 x 4.10 13 x 4.10
Tire pressure (psi)
Model
HS710TG
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush (positions)
Gears (forward/reverse)
Tire size 13 x 4.10 13 x 4.10 13 x 4.10
Tire pressure (psi)
All manuals and user guides at all-guides.com
HS650TG HS650TGE
610 610 610
600 600 600
72.5 72.5 73
350 350 350
3 3 3
3+1 3+1 3+1
24 24 24
HS710B HS710TGE
710 710 710
700 700 700
74.5 74.5 75
350 350 350
3 3 3
3+1 3+1 3+1
24 24 24

Troubleshooting

Problem Solution
The engine won't start:
1. Check sparkplug.
2. Check that the spark plug cap is fitted
correctly.
3. Check if the motor is equipped with an
ignition switch.
(It must be activated)
4. Check if the motor is equipped with a
fuel valve.
(It must be activated)
The engine runs unevenly:
1. Check that the choke has been released.
2. Check fuel for impurities.
If the brush will not run:
1. Check that the clutch is adjusted
correctly.
2. Check that the belt is tight.
If the machine will not run:
1. Check that the clutch is adjusted
correctly.
2. Check the belt.
If the machine does not sweep effectively:
1. Check the distance between the brush
and working surface.
14