Advice And Safety - Eads Telecom Connexity M900 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

All manuals and user guides at all-guides.com

ADVICE AND SAFETY

Note:
You are about to use approved equipment of type DECT,
allowing intercommunication for private use between cordless
telephones and a wireless communication system or domestic
radio bases. This equipment can be used if the conditions
specified in the decree dated 13 January 1995 published in
the Official Bulletin 26 January 1995, which defines the
conditions of a general authorisation licence on the basis of
article L89 of the Post and Telecommunication code, are met.
Apart from the equipment approval, the following operating
instructions must be respected, especially considering the
radio-electric frequencies used:
1. Use of DECT equipment is not guaranteed against jamming
caused by other authorised use of radio electric frequencies;
2. DECT equipment can only be used to establish links
between fixed points if these links are not permanent and if
the equivalent radiated isotropic power at the antenna is less
than 50 mW;
3. The conditions of access to a DECT equipment telepoint
network must be defined in an agreement signed with the
operator of the authorised telepoint network concerned.
This equipment must be used at a temperature between
5
o
C and 40
o
C.
Electrical connection: 230 V AC monophase power
supply with the exclusion of installations with an IT-design
defined in the EN 60-950 standard. Note that the network
voltage is classified as excessive according to the criteria of
this same standard.
As a precautionary measure, in case of danger, the
mains power supply block serves as a disconnecting device
for the 230V power supply.
This equipment complies with the appropriate clauses
of CTR6, CTR10, CTR22 DECT specifications and meets
the requirements of the following EC Directives: Low
Voltage Directive (Safety) LVD 73/23/EEC, 93/68/EEC,
and EMC Directive 89/336/EEC, 92/31/EEC, 93/68/EEC.
These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated
in a commercial environment.
This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance
with the instruction manual, may cause harmful interference
to radio communications.
CE marking - This certifies the conformity of the
equipment with the regulations which apply in accordance
with the directive R&TTE 1999/5/EC.
Caution: This
equipment is not
guaranteed in
case of failure
following the
introduction of
a tip into the
microphone or
the loudspeaker
and the receiver
holes.
Caution: You
can't throw away
batteries with
household rubbish.
You have to bring
back them to your
distributor or to
drop off them at a
recovery center.
PAGE 57

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Connexity m901Connexity m902

Table des Matières