The Battery; Wall-Mounting Of The Charger - Eads Telecom Connexity M900 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

All manuals and user guides at all-guides.com
BATTERY
Before you use your mobile for the first
time, you must charge it for at least
12 hours. You should subsequently
place the mobile regularly in its charger
to maintain the battery level.
When the battery is low:
• In idle mode, the display shows the
following message:
"Recharge battery".
• During a call, the mobile emits 4 beeps
and displays the message: "Battery 1
min." to warn you that the call will be
cut off in 1 minute.
You must then recharge the battery.
Note: "Bat.:
» is displayed when
installing or replacing battery (in the later
case, when the battery is discharged.
You are advised to carry out a complete
recharge for at least 12 hours.
WALL MOUNTING OF THE
CHARGER
1 - Mark the position of the screws on the
wall using the template below.
2 - Put in the screws (5 mm diameter) leaving
appoximately 5mm to hang the phone on.
3 - Insert the screws in the wall mounting
holes of the charger, push the charger
against the wall and pull downwards
until it latches.
Template 45 mm
Remark: When
there is a significant
discharge, the
mobile hums and
the display turns
itself off. You must
charge the battery
completely.
Caution: If the
charger is in
wall-mounted
position and if you
use your mobile
with the belt clip,
you must remove
the clip before
placing the mobile
in the charger.
5 mm
B
PAGE 56

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Connexity m901Connexity m902

Table des Matières