Clutch Lever; Belt Tension Adjustment - HomePro GHP10140T Guide De L'utilisateur

All manuals and user guides at all-guides.com
(H) Clutch Lever
THIS INFORMATION IS PROVIDED HERE ONLY TO INTRODUCE THE CONTROLS. DO NOT
START THE ENGINE AT THIS TIME. PLEASE READ THIS SECTION AND ALL OPERATING AND
SAFETY INSTRUCTIONS BEFORE STARTING YOUR TILLER.
DO NOT FIX THE CLUTCH LEVER IN DRIVE POSITION BY ANY OTHER MEANS THAN MANUALLY
USING YOUR HAND. DO NOT TIE OR OTHERWISE SECURE THE LEVERS IN DRIVE POSITION.
• TO STOP THE TINES AT ANY TIME RELEASE THE CLUTCH LEVERS.

CLUTCH LEVER

Engages tines into forward. Pulling up the clutch lever toward the handle bar engages the tines.
Releasing the lever stops the tines and brings the tiller to a complete stop.
(I) Adjustments
ENGINE SHOULD BE OFF BEFORE ADJUSTING ANY CONTROLS.
DRAG BAR
Tilling depth is controlled by the height of thedrag bar. To adjust tilling depth:
1. Remove B shape pin and column uniform pin.
2. Adjust the drag bar to position tines at chosen tilling depth.
3. Align hole in drag bar with hole in drag bar and replace column uniform pin and B shape pin.
Drag Bar Up = Shallower tilling.
Place the detent pin in the bottom hole of the depth regulator lever for shallowest tilling.
Drag Bar Down = Deeper tilling.
Place the detent pin in the top hole of the depth regulator lever for deepest tilling.
DO NOT ADJUST TILLING DEPTH UNLESS CLUTCH LEVER IS RELEASED AND ENGINE IS
TURNED OFF.

BELT TENSION ADJUSTMENT

Proper belt tension is critical to good performance. After 1/2 hour of operation, all cables may have to
be adjusted due to initial stretch. Thereafter, check tension after every 2 hours of operation.