Samsung NX58 565 Serie Manuel D'utilisation page 74

Troubleshooting
After self-cleaning
CAUTION
Be careful opening the oven door after a self-cleaning cycle. The oven is still very
hot when the door unlocks. Escaping hot air and/or steam could burn you.
• The internal oven temperature must be below 350 °F for the automatic door
lock to disengage. The door lock must be disengaged before another cooking
function can be set.
• After the oven has cooled, wipe down the oven surfaces with a damp cloth to
remove any ash residue.
• Stubborn spots can be cleaned with a soap-filled steel-wool pad. Lime deposits
can be removed with a cloth soaked in vinegar. Rinse thoroughly after
cleaning.
• If the oven is not clean after one cycle, repeat the cycle. If the oven is still hot,
HOT will appear on the display until the oven is cool enough to start a new
cycle.
• Self-cleaning does not operate within 2 hours after running the self-cleaning
cycle.
74 English
NX58H5 Series_AA_DG68-00526A-14_EN+MES+CFR_WEB.indb 74
Troubleshooting
Troubleshooting
Samsung works hard to ensure that you don't have problems with your new gas
range. If you experience a problem, look first for a solution in the table below. If,
after trying the suggested solution, you're still having trouble, call Samsung at
1-800-SAMSUNG (726-7864).
PROBLEM POSSIBLE CAUSE
There is a gas leak.
You smell gas.
The surface burner knob is
not in the 'off' position, yet
the burner itself is not ignited.
The appliance has been
The range is
installed improperly.
not level.
The leveling leg(s) is (are)
damaged or uneven.
The kitchen cabinets are not
properly aligned and make
the range appear to be not
level.
SOLUTION
Clear the room, building, or
area of all occupants.
Immediately call your gas
supplier from a neighbor's
phone. Do not call from your
phone. It is electrical and
could cause a spark that could
ignite the gas. Follow the gas
supplier's instructions.
If you cannot reach your
gas supplier, call the fire
department.
Make sure the floor is level,
strong, and stable. If the
floor sags or slopes, contact a
carpenter.
Check and level the range.
(See the Installation
Instructions.)
Ensure that cabinets are
square and provide sufficient
room for installation.
2020-06-23 오전 9:09:54