INSTALLING/REMOVING NOZZLE
See Figure 15.
WARNING:
NEVER change nozzles without locking the lock out on
the trigger handle and NEVER point the wand at your
face or at others. The quick-connect feature contains
small springs that could eject the nozzle with some force.
Failure to heed this warning could cause personal injury.
Using the quick-connect collar, changing nozzles is easy.
Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
To connect a nozzle to the trigger handle:
Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
Pull back the quick-connect collar.
Push the nozzle into place in the spray wand.
Push the collar forward so that the nozzle is secured
properly. Check to see that the nozzle is secure.
ABRASIVE
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
All manuals and user guides at all-guides.com
OPERATION
NOZZLE SELECTION GUIDE
SOAP
RINSE
GENTLE
Recommended Nozzle
Page 12 — English
To disconnect a nozzle from the trigger handle once the
cleaning job is complete:
Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
Pull back and hold the quick-connect collar.
Remove the nozzle by pulling it from the quick-connect
collar. Place nozzle in the nozzle storage area on the top
of the machine.
USING THE 6-IN-1 CHANGE-OVER NOZZLE
See Figure 16.
There are six spray pattern settings located on the 6-in-1
Change-Over Nozzle. To select a spray pattern, rotate the
spray selector to the desired setting. Refer to the Nozzle
Selection Guide for more information about which setting
to choose.
HIGH PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
0º
25º
40º
LOW PRESSURE
(FOR SOAP OR
GENTLE RINSE.
NOTE: IF DISPENSING SOAP,
YOU MUST USE ONE OF
THESE SETTINGS)
Long Range
Use With Caution for Certain Applications
Short Range