ELPRO ECOLOG TN2 Mode D'emploi page 18

5. Operation
5.1 Main Menu
Display „On"
Error 5, Module does not respond, during data reading
- The datalogger is not in the measurement mode
- To exit the menu press F3
Seite - 18
Getting Started
ECOLOG
only appears if the logger is in power save mode
and data recording.
By pressing the menu key, the display is switched on for
a few seconds.
Start
only appears if the logger is in external start/stop mode
and is waiting for the external start signal or the start
time

Stop Statuscodes
Enter
only appears if the logger is waiting for the external start
by pressing F1
Resetting the alarm display
only appears when an alarm display exists
No function (exit menu)
THx: Time Stamp marked as D2
TNx: No function (exit menu)
TPx: No function (exit menu)
Printing the short protocol
Scrolling the
measured values
Scrolling the alarms
Printing the
alarm protocol
and logger status
Setting the
internal clock
LCD display test
OFF
ON
Alarm output test
Submenu A
Submenu B
Entire protocol
Prints:
Stop: Switches printer off
Submenu C
Exit menu
D-EZ-6003Bh
11. 2016