Safety Equipment; Tool Parts - DeWalt DWFP12658 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Lead from lead-based paints
• Crystalline silica from bricks and cement and other masonry products
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
WARNING: Use of this tool can generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from
face and body. Always operate tool in well-ventilated area and provide for proper dust
removal. Use dust collection system wherever possible.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if operation is dusty. ALWAYS WEAR CERTIFIED

SAFETY EQUIPMENT:

• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA respiratory protection.
Before operating this tool, carefully read and understand all instructions in
Important Safety Instructions.
Nails
Lengths
Air Inlet
NOTE: Use only D
Fig. 1
A.
Exhaust deflector
B. Selectable trigger
C. Air Inlet with quick
connect coupler
D. Canister
E.
Door latch
F.
Contact tip
G. Depth adjustment wheel
H. Door
I.
Tool-Free Shingle Guide
J.
Trigger lock button
k.
Mode selector button
NAIL SPECIFICATIONS
0.120" (3 mm) diameter, 15º wire collated roofing nails
3/4" (19 mm) - 1-3/4" (44.5 mm)
1/4" NPT (6.4 mm)
WALT approved fasteners
e

TOOL PARTS

A
J
K
F
6 - ENG
DWFP12658
B
H
E
C
G
D
I

Publicité

Table des Matières
loading

Table des Matières