bora PL 540 Notice De Montage Et D'utilisation page 20

Installation of the control box
Insert the control box with the affixed compensation
plates from the inside of the panel through the
prepared holes in the panel. On the front, position the
power-setting collar and
accompanying nut and support bracket at a maximum
torque of 10 Nm.
Finally, you can attach the operating knob. When doing
so, the distance of 18.5 mm must be maintained.
The fine adjustment of the knob distance can be
carried out using the internal adjusting screw and a
hexagon wrench key. Compare the connection data
(voltage and frequency) on the type
All manuals and user guides at all-guides.com
tighten it using the
20
In order to maintain a horizontal position, the control
box has to be affixed to the inside of the front panel
with four screws (e.g. chipboard screws DIN 7997).
Now affix the power-setting collar to the front panel
from the front using two screws.
plate with that on the mains connection before
connecting the control box.
These data must coincide to prevent damage to the
appliance. If in doubt, ask your electrician.
Ensure that the plug remains easily accessible after
the appliance is installed. Plug the cable for the
extractor fan into the designated socket.
D
Compensationp
lates
Power-setting collar