Handling Compact Discs - LEXIBOOK CD200i Mode D'emploi

ALKALINE BATTERY INSTALLATION (NOT SUPPLIED)
Open the battery cover sliding the CD door opening switch [13].
Open the battery compartment [12].
Insert two AA batteries (not supplied) into the battery compartment. Be sure to observe
the proper polarity (the "+" and "-" signs) as indicated inside the battery compartment.
Close back the battery compartment [12] until your hear a "click" sound.
NOTE ON ALKALINE BATTERIES
1.When replacing the alkaline batteries, use two new batteries of the same type. Do not
mix new and used batteries or mix different types of batteries.
2.When inserting the batteries, even if you mistakenly insert one with the wrong polarity,
it will cause the batteries to leak.
3.Does not recharge, heat, disassemble or throw batteries into a fire.
REMEMBER
1.If the symbol " " flashes in the display, the batteries are weak, replace them or use
the AC adaptor.
2.If the Display is blank, i.e. no numbers show when the PLAY/PAUSE button [5] is
pressed, the batteries are dead. Replace them, use AC Adapter or Cigarette Lighter
Adapter (Also check if you have inserted the batteries according to the + and – polarity
as shown).
IMPORTANT NOTE:
Dead or discharged batteries must be recycled or disposed of properly in compliance
with all applicable laws. For detailed information, contact your local solid waste recycling
authority.
RECHARGING AND USING RECHARGEABLE BATTERIES (OPTIONAL)
The rechargeable batteries (Not supplied) should must be fully recharged before being
used for the first time because they may beare low in power or they may have not been
used for a long perido of time (over 60 days)"
1.Open the battery compartment cover and insert two rechargeable batteries of the
recommended type, matching the polarity. (1.2V 650mA)
5 Copyright © Lexibook 2004
All manuals and user guides at all-guides.com
ALL BATTERIES MUST BE RECHARGEABLE OF THE NICKEL-CADMIUM TYPE,
OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK.
2.Plug in the AC adaptor [14] and set the Chargeing switch [18] to the ON position to
start recommended type, matching the polarity. (1.2V 650mA)harging the batteries.
WHEN CHARGING THE BATTERIES, PLEASE USE ONLY THE AC ADAPTOR
(OPTIONAL) WITH THE UNIT.
3. After 15 hours, please unplug the AC adaptor and switch the charge. Charging switch
[18] back to the OFF position.
DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO CAN
SERIOUSLY AFFECT THE PERFORMANCE OF THE RECHARGEABLE
BATTERIES.
NOTE:
you may play a CD while the batteries are being recharged.
4.If the operating time decreases drastically even after the rechargeable nickel-cadmium
batteries have been fully charged, please purchase a new set of rechargeable
nickel-cadmium batteries.
5.When charging for the first time or after a long period of charge, playing time
may be reduced. In this case, recharge and discharge the batteries several times.

HANDLING COMPACT DISCS

This unit is designed to play compact discs bearing the
identification logo shown on the right.
Discs that do not carry this logo may not comply with CD
standard and may not play properly.
Dirty, scratched or warped discs may cause the player to
skip or to make noise. Please handle the disc only by the
edges. To keep the disc clean, do not touch its surface.
1.Disc should be returned to their cases after use so as to avoid receiving serious
scratches which could cause the laser pickup to skip.
2.Do not expose discs to direct sunlight, high humidity, or high temperatures for
extended periods of time. Prolonged exposure to high temperatures can warp the disc.
3. Do not apply paper or write anything on either side of the compact disc. Sharp writing
instruments, or the inks used in some felt-tip pens, may damage the surfaces of the
disc.
6 Copyright © Lexibook 2004