Woodbridge SBR4832S Manuel D'installation page 6

WOODBRIDGE
5. Lower base over center of draining pipe and put into place by applying pressure to ensure that the light mortar
is in contact with the en re bo om of the shower base (Figure 5). Verify that the base is level.
6. Once the drain is connected, plug the drain and fill the base with a small amount of water. Check for any
leakage around the drain (some bubbles may appear) and all other areas (below the base for example). Then,
unplug the drain and make sure that the drainage is efficient. There should not be any puddle of water
accumula on in the base.
7. Drill and screw the base onto the 2" X 3" using no. 6 X 1 3/8" screws (preferably stainless steel screws) (Figure
6).
8. Install drywall over the ling flange, then remove the remainder of the plas c film on the shower base.
9. Proceed with the finish such as the installa on of ceramic les or other (see ps in Figure 7 to achieve a
professional looking and water ght finish). Once everything is finalised, install the stainless steel grid on top of
the drain.
FIGURES
Figure 1
Modèle
Model
A B
SBR4832S 32'' 48''
32'' 60''
SBR6032S
SBR4836S 36'' 48''
SBR6036S 36'' 60''
SBR6030S 30'' 60''
SBR6034S 34'' 60''
* Tolérance sur les dimensions : +/- 1/4''. Veuillez toujours
u liser la base de douche pour déterminer les dimensions
finales.
* Tolerance on dimensions: +/- 1/4''. Always use the shower
base to determine the final dimensions.
Figure 2
Tuyau de renvoi
Drain pipe
Plancher | Floor
Trou de
diamètre 5" pour
le drain
5" diameter hole
for the drain
Le tuyau de renvoi de 2" doit dépasser de
1/2'' du plancher existant | The 2" drain
pipe should project 1/2'' above floor line
R
Dimensions*
C D E
3 ½'' 16'' 8 ⅜''
3 ½'' 16'' 8 ⅜''
3 ½'' 18'' 8 ⅜''
3 ½'' 18'' 8 ⅜''
3 ½'' 15'' 8 ⅜''
3 ½'' 17'' 8 ⅜''
Grille
Base de
Strainer
Rondelle
douche
mince
Shower base
Thin washer
Écrou | Nut
Tuyau de renvoi
Rondelle mince
Thin washer
www.woodbridgebath.com www.woodbridgebath.com
E
D
A
C
Figure 3
Drain pipe
B
6