7. Press the START|PAUSE button to start
steaming. RAPID START will flash on the
LCD screen while the steamer heats up.
8. The steaming level (HIGH/LOW) will
flash when steam is being produced. The
timer will start counting down.
9. After the steaming time is finished, the
steamer will beep three times. If KEEP
WARM was enabled, the steamer will
automatically enter KEEP WARM mode
for 15 minutes. When KEEP WARM is
finished, the steamer will beep one time.
Split zone steaming
The steaming area can be divided into two
separate zones to cook foods that require
different steaming level and cooking times.
The LCD screen will display two separate
timers.
1. Fill the water tank with clean tap water.
Ensure the MAX level on the water
window is not exceeded.
2. Place the drip tray and the steaming tray
on the steamer base.
3. Place the food into one or both of the
steaming baskets and close the basket lids.
4. Press the POWER button.
5. Press the SPLIT ZONE button. The LCD
screen will display two steaming levels
and two timers.
6. Set the steaming time for each zone by
pressing the up and down arrows on each
side of the control panel. The steaming
time can be set from 1–45 minutes.
12
7. Press STEAM button on each zone to
select steaming level, steaming with
automatic KEEP WARM or KEEP WARM
only. See page 11 Using STEAM button
section.
8. Press the START|PAUSE button to start
steaming. RAPID START will flash on the
LCD screen while the steamer heats up.
9. The steaming level (HIGH/LOW) will
flash when steam is being produced. The
timer will start counting down.
10. After the steaming time is finished for
each zone, the steamer will beep three
times. If KEEP WARM was enabled, the
steamer will automatically enter KEEP
WARM mode for 15 minutes. When KEEP
WARM is finished, the steamer will beep
one time.
Synchronized finish
If you have set different cooking times for
split zone steaming, use the SYNC FINISH
function to ensure your entire meal is ready
at the same time. The synchronized finish
function will automatically delay starting the
zone with the shorter steaming time so that
both zones finish steaming at the same time.
1. Press the SPLIT ZONE button for split
zone steaming.
2. Press the SYNC FINISH button to enable
synchronized finish mode.
3. Set the steaming level and time for each
zone and proceed as directed for split
zone steaming.