Installation; Points To Be Paid Attention To When The Relocation Of The Refrigerator; Electrical Connection - Blomberg BRFB1052FFBIN Manuel D'utilisation

Masquer les pouces Voir aussi pour BRFB1052FFBIN:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3

Installation

B
In case the information which are
given in the user manual are not
taken into account, manufacturer will
not assume any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
1. Your refrigerator should be
unplugged.Before transportation of
your refrigerator, it should be emptied
and cleaned.
2. Before it is re-packaged,
shelves, accessories, crisper, etc.
inside your refrigerator should be
fixed with adhesive tape and secured
against impacts. Package should
be bound with a thick tape or sound
ropes and the transportation rules
on the package should be strictly
observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the refrigerator,
Check the following before you
start to use your refrigerator:
1. Attach 2 plastic wedges as
illustrated below. Plastic wedges are
intended to keep the distance which
will ensure the air circulation between
your refrigerator and the wall. (The
picture is drawn up as a representation
and it is not identical with your
product.)
2. Clean the interior of the
refrigerator as recommended in the
"Maintenance and cleaning" section.
All manuals and user guides at all-guides.com
refrigerator to the wall socket. When
the fridge door is opened, fridge
internal lamp will turn on.
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give rise
to noise, even if the compressor is not
running and this is quite normal.
may feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.

Electrical connection

socket which is being protected by a
fuse with the appropriate capacity.
Important:
with national regulations.
• The power plug must be easily
• Electrical safety of your refrigerator
• The voltage stated on the label
• Extension cables and multi plugs
B
B
13
EN
3. Connect the plug of the
4. When the compressor starts to
5. Front edges of the refrigerator
Connect your product to a grounded
The connection must be in compliance
accessible after installation.
shall be guaranteed only if the earth
system in your house complies with
standards.
located at left inner side of your
product should be equal to your
network voltage.
must not be used for connection.
A damaged power cable must be
replaced by a qualified electrician.
Product must not be operated before
it is repaired! There is the risk of
electric shock!

Publicité

Table des Matières
loading

Table des Matières