Installation - AquaScape DIY Backyard Waterfall Kit Instructions Et Entretien

Installation

STEP 1
SELECT YOUR LOCATION
• When choosing the location for your new waterfall, we
recommend putting it near a deck or patio so you can sit
and relax close to your water feature. Also keep in mind
viewpoints from inside the house. Make your new waterfall
visible from a kitchen window or patio door, giving you year
round enjoyment. Make sure your waterfall and stream
face the viewing area.
• For this waterfall kit you will need roughly a 32"W x 48"L
area for the basin of the falls and a maximum 3' stream
and waterfall (Ex. 1).
48"
32"
Pondless
Waterfall Vault
STEP 2
CAREFULLY REMOVE CONTENTS FROM BOX
• Verify all parts are present. Read instructions carefully.
STEP 3
ASSEMBLE AQUABLOX
• Line up the pegs with the corresponding holes on the
panels and follow the pattern in (Ex. 3) to assemble the
AquaBlox (Ex. 2 and Ex. 3). A rubber mallet can be used to
tap the pegs into place.
aquascapeinc.com | CAN (866) 766-3426 |
☎
1
3
5
7
STEP 4
Waterfall Spillway
AquaBlox
PLACE PONDLESS VAULT AND AQUABLOX
• Lay out the AquaBlox and the Pondless Waterfall Vault in
Ex. 1
desired location. The AquaBlox should be placed side by
side with the wider panel face down. Place the AquaBlox
over the front edge of the Pondless Waterfall Vault (Ex. 4).
• Use a can of brightly colored, highly visible spray paint to
outline the shape around the Pondless Waterfall Vault and
AquaBlox. This will help mark out the area to be excavated
(Ex. 5).
Ex. 2
☎ US (866) 877-6637
2
4
6
8
Ex. 3
Ex. 4
Ex. 5
5