How To Operate - NOSTALGIA PRODUCTS TACO TUESDAY Manuel D'instructions

Attaching and Removing the Grinding Cage
It is very important that the Grinding Cage is assembled properly in order
for the unit to work.
1. The Grinding Cage is attached to the inside of the
Blending Chamber with a round Plastic Collar.
2. Place the Grinding Cage with the smooth end
(opposite of end with three tabs) into the Plastic
Collar and twist until the notch of the Grinding
Cage locks into the protrusion on the Plastic Collar.
3. Turn the assembled Grinding Cage with Plastic
Collar over, so Plastic Collar
is on the top to insert into the base of Blending
Chamber.
4. Looking down into the interior of the Blending
Chamber, you will see two stainless steel screws.
This is where the clips attached to the Plastic
Collar lock the grinding mechanism down.
5. When putting the Plastic Collar into position,
align the Tabs with the indents in the base
of the Blending Chamber. With firm but
gentle pressure, press the Plastic Collar
down until the Clips "click" into place.
6. Once everything is in place, make sure
the Clips are pushed inward toward the screws to lock the unit into position
and lift slightly to ensure the Grinding Cage is locked into position properly
and will not release. Lock and unlock Clips carefully to avoid breaking.
NOTE: IF THE PLASTIC COLLAR IS NOT LOCKED PROPERLY
THE UNIT WILL GRIND BUT WILL NOT DISPENSE.
Now you are ready to enjoy cold, refreshing margaritas and drinks
from your TACO TUESDAY TAILGATOR MARGARATOR!

HOW TO OPERATE

1. Before first use, remove all packaging materials and detach Blending Chamber from
Base by sliding the three UNLOCK/LOCK switches to the UNLOCK position.
2. Pour warm, soapy water into the Blending Chamber and
dispense all of the soapy water through the Spout.
3. After dispensing all warm, soapy water, rinse by pouring clean water
into the Blending Chamber and dispense clean water through the Spout
until no soapy residue remains and water comes out clean.
4. Wipe down the TACO TUESDAY TAILGATOR MARGARATOR exterior with a
clean, non-abrasive cloth or sponge. Dry interior and exterior thoroughly
with dry, non-abrasive cloth or sponge. DO NOT put the Base in water.
5. After drying, firmly attach Blending Chamber to Base by placing the Blending Chamber on
top of the Base so that Spout faces forward and slide the three LOCK/UNLOCK switches to
the LOCK position.
7
Plastic Collar Clips
Tabs
Screws
Plastic Collar
Grinder