Eskimo Apex Thermal 26400 Manuel De L'utilisateur page 5

BOLT IDENTIFICATION CHART
Not all bolt sizes shown are included with all shelters. Bolts shown are for size reference only.
Extra hardware may be included in the parts bag.
SEATING ASSEMBLY
#15004
#28058
1
Assemble part #28058 onto #15004 using (4) 1 -1/2 IN
bolts, (4) nuts, and (8) washers. Repeat for other set of
#28058 and #15004 components.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
|
26400 Apex Thermal™ Flip-Style Sled Shelter
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED:
• (2) 7/16" wrenches and/or socket driver
• Cordless drill with #1 Philips head bit
IMPORTANT ASSEMBLY TIP
DO NOT FULLY TIGHTEN ANY NUT AND BOLT COMBINATION
UNTIL INSTRUCTED IN LATER NOTES. THIS WILL HELP WITH
HOLE ALIGNMENT FOR ALL PARTS.
ASSEMBLY TIPS:
• This ice shelter should be assembled in an indoor setting due to the
time and length of assembly. Identify and familiarize yourself with all
parts and hardware before assembly. Allow 1-2 hours for assembly.
• The use of a cordless drill with socket will make assembly of your
ice shelter much quicker. Be sure to set the drill speed on low so
you do not over tighten any nut and bolt combination.
• If a tracking kit is purchased with the shelter it should be mounted
to the sled before assembly of the ice shelter for convenience.
(28058/15004)
ASSEMBLY
2
(A) Assemble #28066 to (2) #26535 using (4) 1 -1/2 IN
bolts, (4) nuts, and (4) washers.
NOTE: The long end of #26535 should face away from #28066.
(B) Slide (28058/15004) assembly onto (28066/ 26535)
assembly as shown.
Operator's Manual
#26535
SEE DETAIL
#28066
5