Jaga STRADA HYBRID Manuel D'installation Et D'utilisation page 39

The unit is in standby. The unit automatically starts a new cycle as soon as the set temperature
has been reached.
Permanently off All functions are disabled until the user switches on the unit via the control panel.
- - 3 speeds . Activator speed is set according to the unit's length.
Control panel operation :
– Mode and activator speed : Hold down [Mode] for 10 seconds until all
– Permanently off : Hold down [Mode] until all
MODE
±10 sec
MODE MODE
Tw < 240C
MODE
Speed 1
MODE
±10 sec
Blue LEDs are flashing in the set mode: the water temperature of the supplied water is too high. (Tw > 24 ̊ C ).
Red LEDs are flashing in the set mode: the water temperature of the supplied water is too low. (Tw < 28 ̊ C ).
The LEDs are blinking in a pattern and in the color that matches the selected mode
Only if the window contact is connecrted and switched on : The window contact is open .
MODE MODE MODE
3.2. CONTROL PANEL ERROR CODES
LED flashes rapidly in the color of the set mode .
MODE
MODE MODE
red LEDs are off.
MODE
MODE
MODE
Speed 2
MODE
MODE MODE MODE
Error sensor [3] - Check the water temperature sensor
Error sensor [4] - Check the room temperature sensor
red LEDs are on.
MODE
Tw > 280C
MODE
Speed 3
MODE
MODE MODE
Standby
EN
MODE
MODE MODE MODE
39