Note
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the
unit. If you attempt to restart before this time delay, the Wine cooler will not start.
To avoid too much condensation when the ambient temperature is higher than 28°C, do not lower the
temperature below 7°C.
When you use the Wine cooler for the first time or restart the Wine cooler after having been shut
off for a long time, there could be a few degrees variance between the temperature you select and the
one indicated on the LED readout. This is normal and it is due to the length of the activation time.
Once the Wine cooler is running for a few hours everything will be back to normal.
DEFROSTING
Defrosting of your wine cabinet is fully automatic. It requires no action on your part.
During operation, you may notice condensation drops forming on the rear inside wall of the cabinet. They
will be eliminated during automatic defrosting.
CLEANING
Before any cleaning, unplug the device from the mains.
Never use abrasives or a scraper sponge when cleaning the inside or the outside of your wine
cabinet.
Remove all accessories (racks, etc.). Wash them using lukewarm water to which has been added a
gentle unscented detergent (dishwashing liquid for example); rinse with bleach water and carefully dry
off.
Wash the inside walls in the same way; pay particular attention to the rack supports
Wash the door seal as well as under the seal.
Plug the wine cabinet into the mains.
From time to time, dust off the condenser behind the device; accumulated dust may reduce the efficiency
of your wine cabinet.
In the event of a prolonged absence, empty and clean out the device; maintain the door slightly open
during the period of non-use.
Electrochromatic glass switch
CARE OF YOUR CABINET
60