iComfort IC1004 Manuel De L'utilisateur page 11

8. REmOTE CONTROl ( )
SEE TAblE NExT PAgE
The remote control is used for the operation of all the functions of the chair
except the operation of Main switch. The functions on the remote control
are activated by pressing the buttons gently.
Connect the AC plug, press the power button, then the massage heads
going back to original position, the light of the lCD is glittering, the calf part
and backrest are lifting together. After that the massage heads stop on the
highest position of the backrest and could use after see the pattern on the
lCD.
REmARk
When every button press down effectively, the corresponding symbol li-
ghts up on the lCD. The light will extinguish automatically after 5 seconds;
under automatic working mode, there are lights corresponding symbol on
the lCD.
Please check that the lCD remote is properly connected before turning the
power on. Do not operate the chair without the remote connected.
11
IC1004.indd 11 31/05/07 08:00:18