Project Download - Lenze EPM-H520 Instructions De Mise En Service

Show/Hide Bookmarks
4.2.2
L

Project download

The HMI Designer can be used to load the project and update the firmware at the same time.
Always update the firmware:
!
– When downloading a project into the keypad for the first time.
– After an update of the "HMI Designer" planning tool.
To do this, open the "HMI Designer" and select the "Firmware" option from the "Download"
!
menu.
The firmware will be updated automatically when a new driver is assigned to the project in the
!
keypad.
Please bear in mind that the download process will be considerably slower whilst the firmware
!
is being updated.
What to do
1. Switch on the PC and start the HMI Designer.
2. Switch on the supply voltage for the keypad.
The unit is initialized.
3. Select system page.
For this, touch the display in the
•
top right & and bottom left
or
•
'
top left and bottom right
corners.
The corner to be touched first must not contain a
field for a selectable object.
The system page appears.
4. Touch the field "TRAN"
The transfer page appears.
Touch the field "MSP" ,
5.
The keypad is ready for receiving data from
the PC as soon as "WAITING FOR
DOWNLOAD FROM MSP" is displayed.
)
(
+
.
.
EDBEPM-H520 DE/EN/FR 4.0
Commissioning
2 2 2 2 2 2 2
1 1 1 1 1 1 1
Port Port Port Port Port Port Port : NET : NET : NET : NET : NET : NET : NET
Driver : CAN Lenze S Driver : CAN Lenze S Driver : CAN Lenze S Driver : CAN Lenze S Driver : CAN Lenze S Driver : CAN Lenze S Driver : CAN Lenze S
Ver Ver Ver Ver Ver Ver Ver : 1.06 : 1.06 : 1.06 : 1.06 : 1.06 : 1.06 : 1.06
Addr VT: NO ADDRESS Addr VT: NO ADDRESS Addr VT: NO ADDRESS Addr VT: NO ADDRESS Addr VT: NO ADDRESS Addr VT: NO ADDRESS Addr VT: NO ADDRESS
Error Error Error Error Error Error Error : NO ERROR : NO ERROR : NO ERROR : NO ERROR : NO ERROR : NO ERROR : NO ERROR
H520 TRANSFER PAGE H520 TRANSFER PAGE
Touch screen BOOT check: Touch screen BOOT check:
Graphic controller BOOT check: Graphic controller BOOT check:
Graphic controller RAM check: Graphic controller RAM check:
Main BOOT and RAM check: Main BOOT and RAM check:
SELECT: SELECT: MSP MSP EXIT EXIT
0 0 0 0 0 0 0
3 3 3 3 3 3 3
PROG PROG PROG PROG PROG PROG PROG
4 4 4 4 4 4 4
TRAN TRAN TRAN TRAN TRAN TRAN TRAN
ESC ESC ESC ESC ESC ESC ESC
OK OK
OK OK
OK OK
OK OK
5 5
75