NEC Audio Base Mode D'emploi page 5

STEP 3-A. Having successfully installed your
audio base, carefully turn the monitor
right side up (Figure 3-A).
STEP 4-A. Connect one end of the short power
cord to the connector on the
audio base and the other end to
the monitor (Figure 4-A).
Figure 4-A
AC OUT
Short Power Cord
STEP 1-B. Connect one end of the short power cord to the connector on the
audio base and the other end to the monitor (Figure 4-A).
STEP 2-B. Connect the captive audio cable to the audio (line) output jack of
your computer system (Figure 1-B).
STEP 3-B. Connect one end of the long power cord to the AC-IN connector on
the audio base and the other end into the AC wall outlet (Figure 2-B).
STEP 4-B. Reconnect your monitor to your computer system as shown in the
monitor User's Manual.
STEP 5-B. Turn on the audio base and adjust the controls for best
sound performance.
Figure 1-B
Figure 2-B
Short Power Cord
AudioBase
3
5
Figure 3-A
AC IN
Long Power Cord
10/24/00, 3:13 PM