CASUALPLAY S.4 REVERSE Mode D'emploi page 16

ADJUSTING THE FOOTREST (illustration 15)
• Pull the tab on the front of the footrest outwards to extend the length.
ADJUSTING THE SAFETY HARNESS (illustrations 16-18)
• Put the parking brake on and make sure the safety harness is open before seating the
child in the pushchair (fig.16).
• Position the child in the pushchair and fasten all the parts of the fastening clasp: chest
straps, abdominal belt and crotch strap (fig.17).
• Adjust the harness chest straps and the abdominal belt to fit the child (fig.18).
ADJUSTING THE BACKREST (illustrations 19-20)
• The backrest has 3 reclining positions. Pull the recliner lever upwards (fig.19), and move
the backrest into position by either lowering it or raising it, (fig.20) release the lever when
the backrest is in the required position.
ADJUSTING THE HEADREST (illustration 21)
• The headrest has 3 heights. To change the height, pull the red handle (A) situated on the
backrest and then the headrest (B), until it is locked in one of the three positions.
WARNING: The child must not be sitting in the seat while any adjustment is made
(changing the direction or fitting or removing the seat).
CHANGING THE DIRECTION OF THE SEAT (illustrations 22-25)
• Put the parking brake on.
• Press the buttons on both sides of the seat. A red signal will appear in the window
(fig.22). Then pull the seat upwards (fig.23).
• Install the seat in the required position (fig.24) and make sure that the green signal
appears in the window indicating that it is correctly fastened (fig.25). The child can now
be seated.
FITTING THE HOOD (illustrations 26-27)
• Fit the hood by inserting the guides on both ends into the slots situated on the sides of
the pushchair (fig.26). A click will indicate it is correctly fastened. To take the hood off,
press the catch on the front of the guide upwards and pull forwards (fig.27).
• The hood has two parts. The lower part can be removed using the middle zip.
FITTING THE RAIN COVER (illustration 28)
• The rain cover is fitted onto the pushchair with the hood open.
• Fasten the zip situated on the front part of the hood and the elastic strip with Velcro
situated on the lower front part around the tubes of the chassis.
ADJUSTING THE HANDLEBAR (illustration 29)
• Press the central button on the handlebar and pull it upwards until it reaches the required
height (fig.29).
SAFETY STRAP (illustration 30)
• To use the strap, fit it onto your wrist.
14
All manuals and user guides at all-guides.com