Publicité
Les langues disponibles
Les langues disponibles
Flyware Bracket System
Step 3
Attaching Brackets to Enclosures. Secure the assembled FH1 bracket to the tops of the
neighboring enclosures using the four bolts provided. Tighten bolts in an alternating,
diagonal pattern. Tightening each bolt gradually until all are firmly secured.
Tip: To assure that the bolts do not come loose over time, use a bolt threadlocker (ex. Locktite™,
Permabond™, or Sur-Lok™ brands). This will help ensure the bolt will be locked in place.
After the FH1 top bracket has successfully been mounted on the enclosures, lay
the cabinets on their backs to access the bottoms. Using the supplied Support
Plates, bolt them securely together using the same diagonal pattern as you used
tightening the top bolts.
FIGURE 3a
Step 4
Using Shackles. When the array is in the upright position, a shackle must be used to
fly the array. The multi-pattern holes were designed to give maximum flexibility when
angling the array.
Note: The furthest back hole, in the center of the U-Bracket can be used to achieve the greatest amount
of downward tilt. If even greater tilt is desired, optional 3/8-inch eyebolts may be used as a pullback on the
rear of the cabinets.
Repeat steps as necessary if more than two cabinets need to be arrayed together
in one cluster.
FIGURE 3b
FIGURE4
Canada
Voice: (905) 837-8481
Fax: (905) 837-8746
Yorkville Sound
550 Granite Court
Pickering, Ontario
L1W-3Y8 CANADA
3
FIGURE 3c
U.S.A.
Voice: (716) 297-2920
Fax: (716) 297-3689
w w w . y o r k v i l l e . c o m
Yorkville Sound Inc.
4625 Witmer Industrial Estate
Niagara Falls, New York
14305 USA
Publicité
