Rating Label; Regulatory/Code Requirements; Safety - hestan GFDSR241 Manuel D'installation

RATING LABEL

The rating label contains important information about your Hestan appliance such as the model and
serial number, and refrigerant information if service is required.
EN
The rating label is attached to
the inside top of the cabinet.
REGULATORY / CODE REQUIREMENTS
Installation of this appliance must be made in accordance with local codes. In the absence of local
codes, this unit should be installed in accordance with the National Electrical Code and local codes.
This appliance must be electrically grounded in accordance with local codes or in the absence of
local codes with the National Electrical Code ANSI/NFPA 70 , or Canadian Electrical code CSA
C22.1 .

SAFETY

CHILD SAFETY CHILD SAFETY
DANGER
• Take off the doors.
• Leave the shelves in place so that children may not easily climb inside.
NEVER allow children to play inside the appliance.
PRIOR TO INSTALLATION PRIOR TO INSTALLATION
Carefully inspect cabinet for hidden damage. If damage is discovered, file your
claim immediately with the transport company. Hestan is not responsible for
damage in transit. Remove any packaging materials before operating.
DANGER
the refrigerant tubing or increasing the risk of a leak.
shelving or door handles, as damage to the unit could occur if not moved as instructed.
Before moving the unit, secure the door shut with tape to prevent door from swinging open while
being moved. Carefully move unit to installation site and place in front of opening.
PLUMBING PLUMBING
Aside from connections to the beer tap and keg (see page 11), no other plumbing connections are
required. Condensate from the cooling coil is automatically evaporated through a condensate pan
located in the condensing section of the unit.
4
©2021 Hestan Commercial Corporation
RATING LABEL
Risk of child entrapment. Before you throw away your old
refrigerator or freezer:
RISK OF FIRE OR EXPLOSION - FLAMMABLE REFRIGERANT USED.
Use caution when handling, moving and using the product to avoid damaging
When moving the unit, be sure to protect finished flooring with appropriate
material to avoid damage from moving the unit. Do not lift unit by drawer,
To prevent personal injury, a minimum of two people are required to lift the
unit. Larger units may require additional personnel.
If unit has been laid on its back or sides, place unit upright and allow a
minimum of 24 hours before connecting power.