Associating The Detector With The System; System Test; Technical Characteristics - DELTA DORE DTX Notice D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Associating the detector with the system

The control unit must be in Maintenance mode (press the ON
and OFF buttons simultaneously for 5 seconds on an already
recognized control unit until the control unit emits a beep).
The front panel LED flashes.
Open the battery cover of the control unit.
Go to the "Product" menu on the
control unit
- Press the "ON" button for more than 5
sec. on an already recognized control
unit,
The control unit emits a beep and the
front panel LED is steady.
Record the detector
- Press the detector's test button
until the control unit emits a
beep.
- The control button emits a
beep and its "1" LED (detector)
switches on (this LED is already
lit if a detection element has
already been recorded).
- Close the battery cover of the
control unit.
- 17 -
All manuals and user guides at all-guides.com
Beeep
5 sec.
BeeeP
BeeeP
1
alarm
1
2
tamper
3
battery
4
supervision
5
means of entry
remove
test

System test

• Trigger a detection action
(see manufacturer's instructions for the associated sensor)
• Check that the detection occurs correctly
(see § Operating principle)

Technical characteristics

- Radio range: 200 to 300 metres outside depending on the
equipment associated (the range can be altered depending
on the installation conditions and the electromagnetic
environment)
- Radio frequencies: 434 and 868 MHz, class I
- Power supply: 2 LR03 (or AAA) type 1.5 V alkaline batteries
- Average stand-by mode consumption: 12 µA
- Average consumption for transmission: 15 mA
- Autonomy: 3 years for normal use
- Maximum cable length between transmitter and sensor:
3 metres
- Protection index: IP30
- Use: dry interior only
- Dimensions: 102 x 32.5 x 31 mm
- Operating and storage temperature: -10°C / +55°C
Device complying with the requirements of
the R&TTE 1999/5/EC directive
Because of changes in standards and equipment, the characteristics given in the text
and the illustrations of this document are not binding unless confirmed by Delta Dore.
- 18 -

Publicité

Chapitres

Table des Matières
loading

Table des Matières