Samsung HW-R47M Mode D'emploi page 16

4. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
STANDBY
LINK
5. If the SWA-8500 does not connect, take the necessary steps according to the
LED Indicator's status
LED status
On
LINK (Blue)
Blinking
STANDBY
On
(Red)
Others -
Blue is On
Connected with the Soundbar
Connection standby status
Connection failure
Errors
ENG - 10
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Soundbar and the
Wireless Receiver Module.
Action
-
Check if the Soundbar is turned on
Repeat steps 3 through 4.
Check if the Soundbar is turned on
1. Press the ID SET button on the back of the
Wireless Receiver Module with a pen tip for
5~6 seconds until the LINK LED indicator
blinks (in Blue).
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
L R
SURROUND SPEAKERS OUT ID SET
SPEAKER IMPEDANCE : 3
ID SET
2. Repeat steps 3 through 4.
POWER
Contact a Samsung Service Center.
POWER
5 Sec