Special Safety Instructions - Matrix AG 900-125-1 Traduction De La Notice Originale

All manuals and user guides at all-guides.com
the safety of the power tool is maintained.

4. Special safety instructions

Safety Warnings Common for Grinding,
or Abrasive Cutting-Off Operations
• This power tool is intended to function as a
grinder or cut-off tool. Read all safety
warnings, instructions, illustrations and
specifications provided with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
• This power tool is not recommended for
polishing sanding and wire brushing.
Operations for which the power tool was not
designed may create a hazard and cause personal
injury.
• Do not use accessories which are not
specifically designed and recommended by the
tool manufacturer. Just because the accessory
can be attached to your power tool, it
does not assure safe operation.
• The rated speed of the accessory must be at
least equal to the maximum speed marked
on the power tool. Accessories running faster
than their rated speed can break and fly apart.
• The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool. Incorrectly sized
accessories cannot be adequately guarded
or controlled.
• The arbor size of wheels, flanges, backing
pads or any other accessory must properly
fit the spindle of the power tool. Accessories
with arbor holes that do not match the
mounting hardware of the power tool will run
out of balance, vibrate excessively and may
cause loss of control.
• Do not use a damaged accessory. Before
each use, inspect the accessory such as
16
abrasive wheels for chips and cracks, backing
pads for cracks, tears or excess wear, wire
brushes for loose or cracked wires. If power
tool or accessory is dropped, inspect for
damage or install an undamaged accessory.
After inspecting and installing an accessory,
position yourself and bystanders away from
the plane of the rotating accessory and run the
power tool at maximum no-load speed for one
minute. Damaged accessories will normally break
apart during this test time.
• Wear personal protective equipment.
Depending on application, use face shield,
safety goggles or safety glasses. As
appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments. The eye protection must
be capable of stopping flying debris generated by
various operations. The dust mask or respirator
must be capable of filtrating particles generated
by your operation. Prolonged exposure to high
intensity noise may cause hearing loss.
• Keep bystanders a safe distance away from
the work area. Anyone entering the work area
must wear personal protective equipment.
Fragments of workpiece or of a broken
accessory may fly away and cause injury beyond
immediate area of operation.
• Hold the power tool only by the insulated
gripping surfaces when performing an
operation where the cutting accessory may
contact hidden wiring or its own cord. Contact
with a "live" wire will also make exposed
metal parts of the power tool "live" and
shock the operator.
• Position the cord clear of the spinning
accessory. If you lose control of the power tool,
the cord may be cut or snagged and your hand or
arm may be pulled into the spinning accessory.
• Never lay the power tool down until the
accessory has come to a complete stop. The