Drill Materials; Maintenance; Clean The Machine; Technical Data - GreenWorks DD24L01 Manuel D'opérateur

WARNING
Release the switch trigger and let the chuck come to a
complete stop.
WARNING
Let the chuck to come to a complete stop before changing
the direction of rotation.
The machine does not operate until the reversing button is
pushed fully to the left or right.
8.7

DRILL MATERIALS

• When drilling hard, smooth surfaces, use a center punch
to mark the desired hole location. This can prevent the
drill bit from slipping off-center as the hole is started.
• When drilling metals, use a light oil on the drill bit to
keep it from overheating. The oil can prolong the life of
the bit and increase the drilling action.
• If the bit jams in the workpiece or if the drill falls, stop to
use the machine immediately. Remove the bit from the
workpiece and analyze the cause of the jam.
This drill has an electric brake. When the switch trigger is
released, the chuck stops turning. When the brake is
functioning properly, sparks can be visible through the vent
slots on the housing. This is normal and is the action of the
brake.
WOOD DRILLING
For maximum performance, use high speed steel bits for
wood drilling.
1. Operate the machine at a very low speed to prevent the
bit from slipping off the starting point. Increase the speed
as the drill bit bites into the material.
2. When drilling through holes, put a piece of wood behind
the workpiece to prevent ragged or splintered edges on
the back side of the hole.
METAL DRILLING
For maximum performance, use high speed steel bits for
metal or steel drilling.
1. Operate the machine at a very low speed to prevent the
bit from slipping off the starting point.
2. Hold consistent speed and pressure to avoid overheating
the bit. Applying too much pressure can: Overheat the
drill; Wear the bearings; Bend or burn bits; and Produce
off-center or irregular-shaped holes.
3. When drilling large holes in metal, start with a small bit,
then finish with a large bit. Also, lubricate the bit with oil
to improve drilling action and increase bit life.
NOTE
NOTE
English
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9.1

CLEAN THE MACHINE

The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
10

TECHNICAL DATA

Voltage
Motor
No Load Speed
Chuck
Clutch Settings
Torque
Weight Without Battery
Battery Model
Charger Model
The recommended ambient temperature range:
Item
Appliance storage tempera-
ture range
Appliance operation temper-
ature range
9
CAUTION
CAUTION
WARNING
CAUTION
24 V
Brushless
-1
0-450 / 0-1700 min
13 mm Keyless
20 Positions + Drill + Ham-
mer
450 In-lbs
3.1 lbs (1.4 kg)
BAG708 and other BAG ser-
ies
CAG801 and other CAG ser-
ies
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
EN