Stop The Machine; Led Light; Two-Speed Switch; Select The Mode - GreenWorks DD24L01 Manuel D'opérateur

EN
8.2

STOP THE MACHINE

1. Release the trigger to turn the machine OFF.
Release the trigger and allow the machine to come to a
complete stop.
8.3

LED LIGHT

4
The LED light illuminates when the trigger is depressed.
It provides extra light for increased visibility.
8.4

TWO-SPEED SWITCH

The machine has a two-speed switch designed for drilling or
driving at LO (1) or HI (2) speeds. A slide switch is on top of
the machine.
1. When you use the machine in the LO (1) speed, the speed
decreases and the machine has more power and torque.
2. When you use the machine in the HI (2) speed, the speed
increases and the machine has less power and torque.
Use LO (1) speed for high power and torque applications
and HI (2) speed for fast drilling or driving applications.
WARNING
WARNING
English
8.5

SELECT THE MODE

A
To change the operation mode, adjust the mode selection ring
to the correct position.
The machine is used for three functions: driver (a), drill (b)
and hammer drill(c).
Torque can not be adjusted until the driver (a) mode starts.
A. The direction to decrease torque.
B. The direction to increase torque.
When hammer drilling, do not apply too much pressure.
8.6 ADJUST THE REVERSING
BUTTON
The machine has the reversing button (forward/reverse lock)
above the switch trigger to chang the direction of the bit.
1. When the reversing button is on the left side of the
trigger, the bit direction is forward (tightening).
2. When the reversing button is on the right side of the
trigger, the bit direction is reversed (loosening).
3. Put the reversing button in the OFF (center lock) position
to help decrease the possibility of accidental starting
when not operating.
8
c
b
a a
B
NOTE
NOTE