MINN KOTA CR2450 Manuel Du Propriétaire page 4

PAIRING THE MICRO REMOTE TO YOUR CONTROLLER
PAIRING THE MICRO REMOTE TO YOUR CONTROLLER
An i-Pilot controller may pair up to 5 remotes. These five remotes can be a combination of standard i-Pilot remotes and Micro Remotes.
Any additional remotes can be paired using the following steps. Once the maximum number of remotes have been paired, the controller
will start replacing the oldest paired remote in memory with the new remote.
1
a. Power up the trolling motor.
b. Locate the Pair Button at the top of the Control Head.
c. Push and hold the Pair Button down. A consistent
tone will be emitted from the Control Head.
NOTICE:
Make sure the remote stays within range
of the Control Head during the pairing process.
2
d. While holding the Pair Button on the Control Head,
push and hold the High Speed Bypass and
AutoPilot keys on the remote simultaneously.
NOTICE:
When the remote is being paired to
the i-Pilot Controller, the High Speed Bypass
and the AutoPilot buttons need to be held down
simultaneously. Make sure to also hold the Pair
Button on the Control Head to successfully pair the
remote to the controller.
e. Once successfully paired, 3 longer beeps will be
emitted from the Control Head and the remote will
be paired.
NOTICE:
A remote can be paired to one controller
at a time. A controller can have multiple remotes
paired to it.
4 | minnkotamotors.com
Control Head - Ulterra & Riptide Ulterra
Pair
Button
Control Head - Ultrex,
PowerDrive, Riptide
PowerDrive, Terrova &
Riptide Terrova
High Speed
Bypass
AutoPilot
©2019 Johnson Outdoors Marine Electronics, Inc.