Battery Removal - Waterpik WF-13CD Mode D'emploi

1. 5.
Break here
Remove
2.
6.
rear
cover
Break here
3.
7.
Remove
screws
4.

Battery Removal

5.
The product contains battery and/or recyclable electronic waste. In order to protect the environment,
please do not dispose along with household waste. When battery life ends, please dispose or recycle
according to local administrative regulations.
Please contact local waste administrative department for any questions.
If you tend to dispose the battery on your own, for example, for WP-400 models, please discharge
6.
battery fully before removal and follow below steps to remove battery:
1. Power off the device, pull the reservoir release latch and take out the reservoir.
2. Remove the rear cover by breaking the joints at the handle (both sides) and top cover.
3. Remove 6 screws to remove chassis from unit to gain access to battery.
7.
cut 4. Remove tip rotator by prying it off with a flat blade screwdriver
5. Remove chassis from Unit.
6. Flip chassis over to expose battery. Remove two screws
7. Cut these two wires and pry battery out of chassis.
The removed battery should be disposed safely by special recycling center
WARNING: The battery of this product is not replacable. Please do not disassemble the product
unless you want to dispose it. Otherwise the warranty service will be void..
9 9
BATTERY REMOVAL