Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Place housing gasket into position.
6. Install front housing. Make sure gasket is in correct position.
7. Install (2) ¼" x 2" Taptite screws into the same holes as the alignment pins
and (7) ¼" x 2.25" Taptite into holes shown and tighten to 8-10 foot pounds.
8. Spin the output shaft by hand to ensure no parts are binding.
¼" x 2"
Screws
Publicité
Table des Matières
