Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Use crankshaft bolt and washer to tighten clutch assembly to engine crank
shaft. Tighten bolt to 15-18 ft-lbs.
PTO SHAFT
Note: After tightening bolt, check to make sure PTO shaft spins freely by rotating
shaft by hand. If you cannot spin shaft, the clutch might be assembled
incorrectly. If so, loosen bolt and reassemble clutch.
WARNING: DO NOT PROCEED UNLESS CLUTCH AND SHAFT SPINS FREELY
5. Insert (2) brass alignment pins into holes as shown.
Publicité
Table des Matières
