Beper BG.200Y Manuel D'instructions page 10

Ice Shaver Use instructions
How to operate
1. Make sure the unit is unplugged .Place unit on flat, dry surface.
2. Place ice shaving container in main body and fix it by turning the fixing knob counterclockwise. (Figure 2 )
3. Place the mixing paddle in the jar.
4. For mixing shaved ice with other ingredients (juice, syrup) place them in the jar.
5. Slide jar into groove on main body (Figure 4). If you want the mixing paddle to mix ice and ingredients turn
the jar handle clockwise until it stops. The jar handle should be on left side (Figure 5 ). If you don't want to use
mixing paddle leave the jar handle in the middle.
6. Turn ice size selector to desired setting. Fine setting produces finer ice. Coarse setting produces coarser ice .
7. Place ice in ice shaving container. Do not fill ice above MAX line (lid can be closed).
8. Plug cord into outlet.
9. Place lid on main body and turn counterclockwise to engage the interlock switch. The appliance will start and
ice start to come out.
10. To remove jar, turn counterclockwise, slide out and serve.
CLEANING
Disconnect the plug from the electrical socket.
Wash lid, ice shaving container, jar and mixing paddle with hot water and dishwashing detergent. Do not use
abrasive sponges and / or too aggressive detergents.
Clean the main body with a damp cloth.
Do not immerse the main body in water or other liquids.
Technical Information:
Voltage: 220-240V~50/60Hz
Watts: 25W
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
10