Technical Information - Doro CONGRESS 200 Manuel D'utilisation

All manuals and user guides at all-guides.com
English
Settings

Technical information

On the underside of the telephone you will find several switches located within
the battery compartment.
These switches determine certain technical parameters when connecting the
telephone to e. g. a PBX.
Remove the cover by pressing a small screwdriver (up to Ø 2,5mm) or similar
into the hole to the right of the cover.
IMPORTANT!
These switches should only be adjusted by qualified personnel.
1. System Settings
Allow system settings to be changed or not. The settings are locked if the switch
is on . See next page for more information about the system settings.
N
2. Direct connection
Allow direct connection to be activated or not
L q
123 123
3. Recall (R) Button Technology
Select Recall (R) type, either Time break recall ( ) or Earth recall ( ) with
H
the switch / .
H
IMPORTANT!
If you are unsure of the PBX/network requirements initially select the time break position.
H
4. Tone/Pulse Dialling
Select dialling type, either Tone (♫) or Pulse (...) using the ♫/... switch.
IMPORTANT!
If you are unsure of the PBX/network requirements initially select the tone (♫) dialling setting.
Message waiting
You can select between three types of Message Waiting systems: Neon(80-
100V)/LED+ (12VLR)/LED- (48VLR).
Message Waiting Indicator
Many PBX systems use a function called Message Waiting. The telephone can
show if a call was received in you absence by flashing the Message Waiting
Indicator in standby mode. This function operates differently depending on the
PBX in question. Please contact the system controller for more information.
www.doro.com 9