Sterling Ensemble 7612 Serie Guide D'installation page 19

Fill with water at least 2" (51 mm)
above the highest jet.
Turn the jet trim ring
clockwise to
decrease the flow.
Turn the jet trim ring counterclockwise
to increase the flow.
15. Confirm Proper Operation
Inspect the Installation
Verify all electrical connections.
Verify that the pump banding straps have been cut.
Fill the Whirlpool
NOTE: The whirlpool jets are adjustable. Turn the jet trim ring to increase or decrease the flow.
Position all jet nozzles so they face down toward the basin.
Fill the whirlpool to at least 2" (51 mm) above the top of the highest jet.
Confirm Operating Sequence
Press the air switch to turn on the whirlpool jets.
Verify that the pump starts and operates without excessive noise or vibration.
Verify that water is circulating and flowing from each jet.
Adjust each jet for optimum flow. Turn the trim ring to increase or decrease the flow.
Press the air switch a second time to turn off the whirlpool.
Drain the whirlpool.
16. Install the Apron Access Panel
IMPORTANT! Risk of product damage. Ensure that the tabs are aligned before pressing the apron panel
into place. Improper alignment can damage the clips.
Ensure that the apron area is free from obstructions.
Align the center clip of the access panel with the center slot of the apron frame.
Press the center clip until the apron panel snaps into place.
Slide the apron panel up under the apron frame until the two top clips engage and the apron panel
aligns with the remaining clip positions.
When positioned, press on each of the remaining clip locations to engage the snap-in clips.
Sterling
Position the jet
nozzles to direct
the water flow as
desired.
19
Press the air switch to turn the
whirlpool on or off.
1032207-2-H