Sterling Ensemble 7612 Serie Guide D'installation page 11

6. Cut the Pump Banding Straps
IMPORTANT! This step is necessary to make your whirlpool operate more quietly.
IMPORTANT! Do not raise the pump higher than it was before you cut the pump banding straps. If the
pump is raised too high, it will not prime properly.
Cut the two pump banding straps from the whirlpool pump with a pair of tin snips.
Make sure the pump is not in direct contact with the whirlpool harness.
7. Connect the Drain
Connect the drain to the trap according to the manufacturer's instructions.
Check the drain connections for leaks.
Sterling
Leave the pump
support bracket
attached to the
whirlpool.
Pump
Cut the pump
banding straps.
Pump Support Bracket
Suction Line
11
Drainage
1032207-2-H