Important - GrillMaster 720-0783 Mode D'emploi

11. Connecting LP Gas Tank to LP Grill
(a) From front of the cart, turn the locker to the right and
pull out of tank tray seat, place foot ring of 20 lb tank
into the hole in bottom panel. Make sure the tank
valve is in OFF position. Use the tank bolt to secure
the tank in a fixed position, turn locker to left. See
Fig.33.
(b) Check the tank valve to ensure it has proper external
mating threads to fit the hose and pressure regulator
assembly provided.
(c) Make sure all burner valves are in OFF position.
(d) Inspect the valve connection port and pressure
regulator assembly. Look for damage or debris.
Remove any debris. Inspect hose for damage. Never
use damaged or plugged equipment.
(e) When connecting pressure regulator and hose
assembly to tank valve, hand tighten quick coupling
nut clockwise to a full stop. See Fig.34. Do not use a
wrench to tighten because it could damage the quick
coupling nut and result in a hazardous condition.
(f) Slowly open tank valve fully (counterclockwise). Use
a soapy water solution to check all connections for
leaks before attempting to light your grill (see page leaks before attempting to light your grill (see page
20 for gas leak check instructions). If a leak is found,
turn tank valve off and do not use your grill until the
leak is repaired.
CAUTION: When the appliance is not in use, gas
must be turned off at the supply tank.
DISCONNECTING THE LIQUID PROPANE
CYLINDER
Turn the grill burner valves "OFF" and make sure the
grill is cool.
Turn the Liquid Propane Cylinder valve "OFF" by
turning clockwise until it stops.
Detach the pressure regulator assembly from the
cylinder valve by turning the quick coupling nut
counterclockwise.
Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap
on the cylinder valve outlet that is provided with the
cylinder valve. Other types of caps or plugs may
result in leakage of propane.
Fig.33
a
c
Fig.34
Pressure Regulator
Connection
Your GrillMaster® gas grill is now ready for use.
Before the first use and at the beginning of each
season (and whenever the LP gas tank has
been changed):
1. Read all safety, lighting and operating
instructions.
2. Check gas valve orifices, burner tubes and
burner ports for any obstructions.
3. Perform gas leak check according to
instructions found on page 20 of the manual.
Before cooking on your grill the first time, wash
cooking grids and cooking rack with warm ,
soapy water. Rinse and dry thoroughly. Season
with cooking oil regularly. After cooking is
completed, turn grill to HIGH setting for 3 to 5
minutes to burn off excess grease or food
residue.
19
b
d
Congratulations Congratulations

Important