Technical Specifications - Nice mindy TT0 Instructions Et Recommandations Pour L'installateur

If you need to delete all the data contained in the memory of the control unit, carry out the following procedure.
The memory can be deleted:
• with a non-memorised transmitter starting from point A.
• with a previously memorised transmitter starting the procedure from point N° 1
The following can be deleted:
• only the transmitter codes, finishing at point N° 4
• all data (transmitter codes, directions, wind levels, TTBUS addresses, etc.), completing the procedure.
Table "A5" Memory deletion (fig. 8)
➨
A Switch the motor off, activate the Step-by-Step input and keep it active until the end of
the procedure
B Power the motor and wait for the 2 initial beeps
➨ Press and hold down button ■ of a transmitter until you hear a beep
1
(after about 5 seconds)
Hold down the ▲ button of the transmitter until you hear 3 beeps; release the ▲ button
2
exactly during the third beep
Hold down the ■ button of the transmitter until you hear 3 beeps; release the ■ button
3
exactly during the third beep
➨ Hold down the ▼ button of the transmitter until you hear 3 beeps; release the ▼ button
4
exactly during the third beep
If you wish to delete all the data, press the ▲ and ▼ buttons together within 2 seconds and
5
then release them.
After a few seconds 5 beeps signal that all the memorised codes have been deleted.
4) What to do if...
a small troubleshooting guide!
When the board powered, the 2 beeps will not be heard
and the Step-by-Step input does not control any move-
ment.
Check the control unit is correctly powered: mains voltage must be
present between terminals 6-7, a voltage of about 24Vdc must be
present between terminals 8-10 with the Step-by-Step button dis-
connected. Check the 5A fuse F1 if necessary.

5) Technical specifications

Electronic control unit
Power input
Maximum power of motors
Signal voltage (step-by-step, sensors)
Working temperature
Dimensions / weight
Protected to "IP"
Wind sensor (anemometer) levels
Length of signal cables (step-by-step, sensors)
Radio receiver
Frequency
Coding
Range of ERGO and PLANO transmitters
Nice S.p.a. reserves the right to modify its products without any notice
After a radio command, 6 beeps are heard and the
manoeuvre does not start
The radio control unit is out of sync, repeat the transmitter code
storing procedure.
After a command, 10 Beeps sound and then the manoeu-
vre begins
The self-diagnosis of the stored parameters has revealed a fault
(TTBUS addresses, wind speed and sun power, directions are incor-
rect). Check and repeat programming if necessary
: 230Vac 50/60Hz or 120Vac 50/60 Hz depending on the versions
(see value on label)
: 600W for 230Vac version; 400W for 120Vac version
: Approx. 24Vdc
: -10 ÷ 70 °C
: 120 x 80 x 50 300 g
: 55 (casing undamaged)
: Approx. 30 or 15 or 45 km/h (with anemometer at 0.4 Hz per km/h)
: max. 30m if near other cables, otherwise 100m
: 433.92 MHz
: 52 Bit rolling code FLOR
: Estimated 200 m in the open air without obstacles and 35 m inside buildings.
GB
Example
PP
5s
within 2 s
5