Kawasaki K-ED-E 810 Traduction De La Notice Originale page 17

7.2 Fitting and adjusting the depth stop
(Fig. 4/Item 2)
The depth stop (2) is held in place by the
additional handle (8) by clamping. The clamp can
be released and tightened by turning the handle.
• Release the clamp and fit the depth stop (2) in
the recess provided for it in the additional handle.
• Set the depth stop (2) to the same level as the
drill bit.
• Pull the depth stop back by the required drilling
depth.
• Turn the handle on the additional handle (8)
until it is secure.
• Now drill the hole until the depth stop (2)
touches the workpiece.
7.3 Fitting the drill bit (Fig. 5)
• Always pull the power plug before making
adjustments to the equipment.
• Release the depth stop as described in 7.2 and
push it towards the additional handle. This
provides free access to the chuck (1).
• This hammer drill is fitted with a keyless chuck
(1).
• Open the chuck (1). The drill bit opening (1)
must be large enough to fit the drill bit into.
• Select a suitable drill bit. Push the drill bit as far
as possible into the chuck opening.
• Close the chuck (1). Check that the drill bit is
secure in the chuck (1).
• Check at regular intervals that the drill bit or tool
is secure (pull the mains plug).
8. Operation
8.1 ON/OFF switch (Fig. 6/Item 5)
• First fit a suitable drill bit into the tool (see 7.3).
• Connect the mains plug to a suitable socket.
• Position the drill in the position you wish to drill.
To switch on:
Press the ON/OFF switch (5)
Continuous operation:
Secure the ON/OFF switch (5) with the locking
button (4).
All manuals and user guides at all-guides.com
To switch off:
Press the ON/OFF switch (5) briefly.
8.2 Adjusting the speed (Fig. 6/Item 5)
• You can infinitely vary the speed whilst using the
tool.
• Select the speed by applying a greater or lesser
pressure to the ON/OFF switch (5).
• Select the correct speed: The most suitable
speed depends on the workpiece, the type of use
and the drill bit used.
• Low pressure on the ON/OFF switch (5): Lower
speed (suitable for: small screws and soft
materials)
• Greater pressure on the ON/OFF switch (5):
Higher speed (suitable for large/long screws and
hard materials)
Tip: Start drilling holes at low speed. Then
increase the speed in stages.
Benefits:
• The drill bit is easier to control when starting the
hole and will not slide away.
• You avoid drilling messy holes (for example in
tiles).
8.3 Preselecting the speed (Fig. 6/Item 6)
• The speed setting ring (6) enables you to define
the maximum speed. The ON/OFF switch (5) can
only be pressed to the defined maximum speed
setting.
• Set the speed using the setting ring (6) on the
ON/OFF switch (5).
• Do not attempt to make this setting whilst the
drill is in use.
8.4 Clockwise/Counter-clockwise switch
(Fig. 6/Item 7)
• Change switch position only when the drill is
at a standstill!
• Switch the direction of the hammer drill using
the clockwise/counter-clockwise switch (7):
Direction
Clockwise (forwards and drill)
Counter-clockwise (reverse)
17
GB
Switch position