Whirlpool AKR 457/1 AL Manuel D'utilisation Et D'entretien page 15

INSTALLATION - ASSEMBLY INSTRUCTIONS
The instructions below, to be carried out in the order in which they are numbered, refer to the drawings (using the same numbering) on the last pages of this
manual.
1. Mark a vertical centre line on the wall.
2. Apply the drilling diagram to the wall (secure it using adhesive tape): the vertical centre line printed on the drilling diagram must be aligned with the
centre line drawn on the wall, and the lower edge of the drilling diagram must be aligned with the lower edge of the hood.
IMPORTANT: The bottom edge of the drilling diagram must be at a distance of at least 45 cm (for electric hobs) or 65 cm (for gas hobs).
3. Make 3 holes as shown in the drawing and remove the drilling diagram.
4. In extractor mode only, with REAR AIR OUTLET: Make a hole in the wall (Ø 16 cm) for the pipe, as shown in the drilling diagram.
5. Fix the 2 support hooks near the upper holes with 2 plugs and 2 screws, and insert 1 plug in the lower hole.
6. In filter mode only: leave the plastic grille at the top in place.
7. In extractor mode only: remove the plastic grille at the top.
8. Open the perimeter hood panel and remove the grease filter.
9. In extractor mode only, with REAR AIR OUTLET:
9.1. Remove the 4 screws securing the extraction unit to the hood.
9.2. Take out the extraction unit.
9.3. Remove the pre-cut plug from the back panel of the hood.
9.4. Rotate the motor as shown in the figure, so that the exhaust hole is facing the back panel.
9.5. Put it back inside the hood (make sure the extraction unit coupling sticks out of the hole at the rear).
9.6. Secure the duct with 4 screws (ref.: 9.1).
9.7. Fix the cover for the hole at the top in place using 2 screws (ref. 9.3).
10. Hook the hood onto the support hooks previously fixed to the wall.
11. Tighten the 2 adjustment screws.
12. Adjust the hood horizontally, using a level and operating on the two adjustment screws.
13. Adjust the distance between the hood and the wall.
14. Secure the hood to the wall with 1 screw and 1 washer.
15. In extractor mode only, with UPPER AIR OUTLET: Connect the fume exhaust pipe to the collar.
16. Connect the electrical cable to the hood socket.
17. Secure the cable to the cable clamp.
18. For filter mode only: Fit the carbon filter onto the back of the grease filter, hooking it with the two rods.
19. Fit the grease filter and close the front panel.
IMPORTANT: Do not damage the electrical connections when rotating the motor.
GB13