Storage After Use; Maintenance; Troubleshooting; Warranty Information - Eureka Ignite Manuel D'instructions

STORAGE AFTER USE

• Allow stove to cool before storing.
• Always disconnect fuel cylinders before storing the stove.
• Ensure stove is clean and dry before storing.
• Store the stove in a cool, dry location, indoors.
To avoid dust and cobweb buildup, which can e ect stove
NOTICE
performance, store the stove in a sealed bag or container.

MAINTENANCE

Flame Check (Every use):
to high with counter-clockwise rotation of the control knobs. Flame should be
blue with minimal yellow tipping. If lame abnormalities are found, refer to
Troubleshooting Section.
Cleaning Stove (Before storage, or as needed):
stove to cool before cleaning. Do not use a dishwasher or abrasive compounds
to clean. Only wash by hand with soapy water.

TROUBLESHOOTING

Flame does not extinguish:
Manually blow out lame. Once lame is extinguished, immediately detach fuel
source. See your dealer or contact Eureka! for service.
Igniter fails to spark:
to spark, use matches or a lighter, following instructions detailed in
OPERATING INSTRUCTIONS – Lighting the Burners. See your dealer or contact
Eureka! for service if igniter fails to spark for any other reason.
If an issue cannot be corrected using these instructions, see Limited Warranty
below.
Contact your local dealer, distributer, or Eureka! for parts and/or service.

WARRANTY INFORMATION

This product is covered by a 1 year limited warranty. Visit
www.eurekacamping.com for additional information.
ANSI Z21.72 2019 / CSA 11.2 – 2019
7
The height of the lame should increase from low
Tighten control valve as much as possible.
If stove is wet, igniter may fail to spark. If igniter fails
Turn stove o . Allow