Assembly - Eureka Ignite Manuel D'instructions

ASSEMBLY

For safe use of your product and to avoid serious injury:
• Perform leak checks outside, in a well-ventilated area.
• Operate at least 1m/3.3ft away from combustible materials and ignition
sources.
• Before each use: Keep stove area clear and free from combustible
materials, gasoline, and other lammable vapors and liquids.
• Do not obstruct the low of combustion and ventilation air to the stove.
• Place stove on a lat, level surface, at least 1m/3.3ft away from any
combustible materials or ignition sources.
• Perform LEAK CHECK PROCEDURE (see pg. 4) before proceeding.
• Release the latch (1.1) to open the lid (1.2). Open side-windscreens(1.3) and
secure by inserting tabs into latches in the lid (1.4).
• Ensure that both control valves (1.5) are closed irmly (rotate clockwise).
• Check that Gasket (2.1) at Fuel Input connection (1.6) is in place and in good
condition before connecting to the Regulator.
WARNING
• Connect Fuel Regulator (3.1) to the Fuel Input port (1.6) located on the center
of the right side of the stove by threading Coupling clockwise.
• Connect Propane Cylinder (4.1) (sold separately) into Fuel regulator (4.2) by
threading clockwise in the orientation shown in Fig. 4.
WARNING
(For Ignite Plus Stoves Only)
• Install the four adjustable feet (6.1) into stove base (6.2) by threading
clockwise as shown in Fig. 6.
5
Do not use the appliance if it has damaged or worn seals;
this may result in gas leakage.
Never operate stove with Propane Cylinder in an inverted
position (Fig. 5). Flaring can occur.
WARNING