Operation Instructions - Eureka Ignite Manuel D'instructions

OPERATING INSTRUCTIONS
• Keep burner at arm's length, away from face, during ignition. Flame can
erupt and lare during ignition.
• Never expose stove to lammable vapors or liquids while lighting the
burner. It can cause an explosion or ire.
• Do not move, lift, or tilt stove with lit burner(s). Flaring may occur.
• Always check that the burners are extinguished before disconnecting the
fuel source. Vapors can ignite and cause serious injury.
Lighting the Burners:
CAUTION
• Open either control valve (1.5) counterclockwise until fully opened and gas
low can be heard.
Note: Our advanced Simmer Control technology requires
2 complete rotations to achieve full gas low.
• To light, depress igniter button (1.7) as shown in Fig. 7. Repeat as necessary.
• If ignition does not occur within 5 seconds, close control valves (1.5) and
wait 5 minutes before repeating the procedure.
Cooking:
Rotate control valve (1.5) of the lit burner clockwise to decrease
lame setting.
Note: Our advanced Simmer Control technology allows 2 complete rotations
of lame adjustment.
After Use:
Turn o open control valves (1.5) (tighten clockwise) to extinguish
lame to each burner.
WARNING
serious injury.
Always disconnect fuel cylinder from Regulator after use.
Remove all vessels from cooking surfaces prior
to lighting.
Always check that the burners are extinguished before
disconnecting the fuel source. Vapors can ignite and cause
WARNING
6