Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle; Option Selections - Whirlpool Inglis ISU5846 Guide D'utilisation Et D'entretien

Rinse Only
Use this cycle for rinsing dishes, glasses, and silverware that will
not be washed right away.
Do not use detergent with this cycle.
Pre- Rinse Main Rinse
Wash Wash
†
A small amount of water runs through the pump to remove soil
particles.

Canceling a Cycle

Anytime during a cycle, press CANCEL/DRAIN. Cancel/Drain
glows. The dishwasher pauses for about 5 seconds and starts a
2-minute drain (if needed). Let the dishwasher drain completely.
The light goes off when the dishwasher finishes the drain.
To stop the drain
You can press CANCEL/DRAIN again to stop the drain
immediately. Be sure to drain the dishwasher before starting a
new cycle.
NOTE: A small amount of water remains in the dishwasher. This
is normal.
To clear the indicators
Press CANCEL/DRAIN before starting the dishwasher to clear all
options and cycles.

Changing a Cycle or Setting

During the first 2 minutes of a cycle
Press a new cycle and/or options.
After the first 2 minutes of a cycle
1. Press CANCEL/DRAIN. Cancel/Drain glows. The dishwasher
pauses for 5 seconds and starts a 2-minute drain (if needed).
Let the dishwasher drain completely.
2. Check the detergent dispensers. If the main wash cup has
opened and the detergent washed away, refill the cups as
needed.
3. Close the door.
4. Press a new cycle and/or options and press START/
RESUME.
All manuals and user guides at all-guides.com
†
Purge Final Dry Time
Rinse (min)
10

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the main wash
section is still closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the spraying
Water
action to stop before opening the door.
Usage
(gal/L)
2. Open the door. If the main wash detergent dispenser is still
2.2/10.0
closed, add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches and press START/
RESUME. The dishwasher resumes the cycle after about a
5-second pause.
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
anytime before drying begins.
After a wash cycle, the dishwasher remembers the options used
and uses the same options in the next wash cycle, unless you
select new options or press CANCEL/DRAIN.
Hi-Temp Wash
Select this high-temperature option for improved cleaning of
heavily soiled dishes. Selecting this option adds heat, water and
time to the wash cycle. Heating the water helps improve washing
results.
NOTE: Hi-Temp Wash is an option with Heavy wash and Normal
wash.
Heated Dry
Select this option to dry dishes with heat.
Switching off Heated Dry saves energy and is useful when loads
contain plastic dinnerware that may be sensitive to high
temperatures. The dishes take longer to dry and some spotting
can occur.
For best drying, use a liquid rinse aid. Some items (such as
plastics) may need towel drying.
NOTE: Heated Dry is an option with all cycles except Rinse Only.

Option Selections

11