Tannoy DB3000-series Guide De Démarrage Rapide page 12

22
CMS 801 Series
Wiring And Setting Up:
1. Open the wiring cover at the back of the speaker can to access the Euro type connector
plug and socket.
2. For connection to an amplifier, use pins 1 and 2:
• Pin 1 is positive
• Pin 2 is negative
For connection to additional speakers in a distributed line, pins 3 and 4 are in parallel where:
• Pin 3 is negative
• Pin 4 is positive
3. Close the wiring cover and tighten both screws on the cable clamp. Use the rotary
switch located on the front of the unit to select whether you wish to use the speaker in a
low-impedance or distributed-line application.
THE SPEAKER IS SUPPLIED IN LOW IMPEDANCE MODE. NEVER CONNECT THE
SPEAKER TO A 70/100 VOLT AMPLIFIER WHILE IT IS SET FOR LOW IMPEDANCE.
All CMS 801 models use a 60 W transformer. When using distributed-line systems,
the transformer can be tapped at 60 W, 30 W and 15 W, with an additional 7.5 W tapping
for 70.7 V line systems.
CMS 801 sub BM Dimensions:
Template hole cutout size: 295 mm
327.8
310.5
[12.90"]
[12.22"]
18.5
[0.73"]
CMS 801 sub PI Dimensions:
Template hole cutout size: 295 mm
1 17.5
[4.63"]
18.5
[0.73"]
CMS 801 PI Back Can Dimensions:
Template hole cutout size: 295 mm
291.4
397.0
[15.63"] [11.47"]
8.8
[0.35"]
Quick Start Guide
286.4
[11.27"]
325.0
[12.80"]
286.4
[1 1.27"]
325.0
[12.80"]
168.5
[6.63"]
365.0
[14.37"]
151.2
[5.95"]
23