Blaupunkt ISD-SD1 Manuel De L'utilisateur page 12

DO NOT INSTALL
PEAK CEILING
Diagram 3
Installation:
· Take off the bracket from the alarm body.
· Press the bracket on the installation posi-
tion, mark installation hole of the bracket
with pencil.
· Bore two installation holes on the sign
with electric drill.
Make diameter of holes is 5mm, Strike the
two plastic plugs into holes with hammer.
· Attach the bracket to the plastic plugs
and fix tightly the screws into the plastic
plugs. (Refer to Diagram 4).
· Optional: you may install a magnetic
plate, for easy usage, maintenance and
changing to new devices. Consult the
retailer, where you purchased the device.
· Fit the alarm on the bracket and turn the
alarm body clockwise, until matching well
on the bracket.
· Press the button for test the unit. The
alarm sounds 3 beeps – 1.5 seconds pau-
se, repeat it until release the button, if no
sound, it indicates a defective alarm, you
can refer to "Trouble shooting" for solution
or return to your retailer during warranty.
· If you have any questions on installation,
you can contact your retailer.
12
DEAD
AIR
Esquema de instalación:
Diagram 4
WARNiNG:
To prevent injury, this unit must be securely
attached to the ceiling in accordance with
the installation instructions.
Disposal:
The product and battery should be disposed
of separately from the municipal waste
stream through designated collection
facilities appointed by the government or
the local authorities.