Lindy LTS-50 Manuel page 4

Charging
Charging the LTS-50
The LTS-50 can be easily charged by enclosing inside the charging case, ensuring the charging points meet those of
the case.
The case has in-built magnets to secure the earphones in place to avoid any hassle positioning the LTS-50.
▪
To begin charging, simply place the earbuds into the charging case and close the charging case.
▪
Please note the LTS-50 will automatically disconnect from the source device once the case is closed.
▪
Each earphone can be independently charged on its own if required. Once both earphones are fully charged,
the charging case will switch off to save power.
▪
The LTS-50 can be charged up to 3 times from a 100% charging case.
▪
The LTS-50 will intermittently beep when they are near low charge. Battery life can also be monitored with
compatible audio source devices.
Charging the Case
To charge the LTS-50, the case must also be charged.
This can be done by connecting the USB Type C cable and connecting to a USB power source.
LED Indicators on Charging Case
▪
Left LED: This will illuminate white to indicate the left earbud is charging. This LED will turn off once the
earphone is fully charged.
▪
Right LED: This will illuminate white to indicate the right earbud is charging. This LED will turn off once the
earphone is fully charged.
▪
Centre LED: This LED will indicate the status of the case.
▪
If the LED is flashing green, this indicates that the charging case is at 100% charge and can be
disconnected from the power source.
▪
If the LED is illuminated green, this indicates that the charging case is at >70% charge.
▪
If the LED is illuminated orange, this indicates that the charging case is at >35% charge.
▪
If the LED is illuminated red, this indicates that the charging case is at <35% charge.
3